residual force

Firstly, the shear strength parameters of slip surface are back-analysised, then quantitive evaluation of landslide is carried out, and the residual sliding force under different conditions are calculated, and abnormal operation mode two is selected as control condition. 3.

首先对滑动面的抗剪强度参数进行反算，然后对滑坡体进行了稳定性定量评价，计算了不同工况下滑坡的剩余下滑力，并选取非正常工况Ⅱ作为抗滑支挡工程设计的控制工况。

The problem of agriculture, rural and farmers rooted from surplus rural population and residual labor force.

“三农”问题的根源在于我国农村人口和农村剩余劳动力过多.

It introduces that how to watch and measure the hysteresis loop-line, residual magnet and coercive force of ferromagnet through an oscillograph.

介绍了如何利用示波器观察和测量铁磁物质的磁滞回线、剩余磁感应强度和矫顽力。

The increase of residual sliding force is prominent because of the occurrence of excess pore water pressure.

超孔隙水压力的存在大幅提高了剩余下滑力值。

Approximate solution of grinding force has been resulted by weighted residual method from grinding bar's deformation.

本文从磨杆的变形反推磨削力的角度,应用加权残数法导出了近似解.

The residual contact force, which is the important reason for the tight connection between the tube and sleeve, exists between the tube and sleeve.

成形后导管管套之间存在的残余接触力，是导管管套紧密连接在一起的重要原因；

By sensitivity analysis, the sequence of factors that influence the critical pile space is: residual slip force of sliding mass, internal friction angle of soil mass, cohesion of soil mass, width of pile.

通过敏感性分析，对于临界桩净间距而言，各影响因素的敏感性大小排序为：滑体剩余下滑力、土体内摩擦角、土体粘聚力、桩宽度。

New idea to control welding residual stress and distortion with trailing impactive electromagnetic force was given.

提出了基于脉冲电磁力随焊控制焊接应力及变形新方法.

Present land laws, household register regulations, the procession of urbanization and the education level of rural residual labor force are the main factor that influence the problem of rural residual labor force transfer.

现行土地制度、户籍管理制度、城市化进程以及农村剩余劳动力素质是制约农村剩余劳动力转移的主要因素。

Using the succession-level approximate reduction technique, results of the residual force algorithm under different level reduced models are discussed through a plane truss structure.

以一个平面桁架结构为算例，比较了残余力向量法在各级缩聚模型下的损伤识别结果。

The lung function tests included maximal voluntary ventilation ( MVV%), forced vital capacity ( FVC), force expiratory volume ( FEV 1) and RV/ TLC% ( residual volume, RV; total lung capacity, TLC).

肺功能检测主要包括最大通气量（MVV）、一秒率（FEV1/FVC%）和残气容积（RV/TLC%）。